Cable trays containing conductors rated over 600 V shall have permanent, legible warnings stating _____.

*Class I division 2 pendant luminaries with rigid stems larger than _____ inches, must have permanent bracing that protects against lateral displacement.

*For heaters that are installed in a Class I Division 2 area, the heater must not be more than of _____% of the auto-ignition temperature in degrees C.

*In a residential kitchen, what is the minimum countertop width that necessitates the installation of at least one receptacle outlet?

*In meeting rooms that have a minimum width of 12 feet and a total floor area of at least 215 square feet, what is the required minimum number of floor receptacle outlets?

*For mobile homes, when bonding the non-current carrying metal parts, you must use a minimum of what AWG conductor(s)?

* In a Class I Div 2 boundary the sealing fitting is allowed to be on either side of the boundry within _____ ft. of the boundary.

*In dwelling units, no less than one 20 or 15 amp receptacle must be installed within _____ ft. of  HVAC Equipment.

*Is metal underground gas piping permitted to serve as a grounding electrode conductor in an electrical installation?

*Outlet boxes shall be installed when on concrete, gypsum, plaster, or other non-combustible material set back no farther than _____ from the finish surface.

*Using the optional method, what size overcurrent protection would you select for a load calculated at a total of 68,000 VA  on a 120/240V system?

*In a 4-wire, delta-connected electrical system, what specific identifying color must be used to mark the high leg conductor?

*For multi-outlet assemblies where the outlets are anticipated to be used simultaneously, what is the volt-ampere value that must be calculated per linear foot of the assembly?

*If a light bulb is rated at 100 watts and it is connected to a standard 120-volt circuit, what is the current in amperes that this light bulb would draw?

*When underground wiring emerges from grade level, it must be provided with protection against physical damage for not less than how many feet?

*In accordance with grounding and bonding requirements, if a single ground rod, pipe, or electrode has a measured resistance to earth that is equal to or less than how many ohms, then the installation does not mandate the placement of a second grounding electrode?

*Which specific type of communication cable is approved for use and installation within a plenum space?

*When a branch circuit is designated to supply neon signs, the circuit rating must not be greater than how many amperes?